CM6533DH
INTRODUCTION

The CM6533DH is a USB 2.0 audio chip built-in 8051 for flexible applications. With integrated Tri-Colors PWM LED driver and two-channel ADC/DAC and S/PDIF interface that makes it suitable for headset, docking, speaker and microphone applications. The internal 8051 can also be developed to a lot of different applications, such as Microsoft™ Lync/Skype/VoIP device, Android Phone or Tablet/Slate docking device. The CM6533DH is compatible with USB Audio Class 1.0 and USB 2.0 Full-Speed, thus it can plug & play without any additional software installation on major operating systems. The internal DAC and ADC support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.

The CM6533DH integrates equalizer on both playback and recording paths to compensate the frequency response of microphone and headphone.

The CM6533DH also integrates 256K Byte flash (Including 32KB F/W programming size) and crystal but requires few passive components to make a finish product. Thus, it can save the total BOM cost and PCB area can be smaller.

 

PRODUCT FEATURES

USB Compliance

  • USB spec. 2.0 full-speed compatible and USB-IF certification
  • USB audio device class spec. 1.0 compliant
  • USB HID device class spec. 1.1 compliant

Architecture

  • USB suspend/resume support
  • Embedded USB transceiver and power-on reset circuit
  • 256K Byte Flash and 32K Byte programming size supported for flexible customizing
  • Integrates 5-Band Hardware Equalizer with up-to-4 preset modes 
  • Built-in Automatic Gain Control (AGC) for microphone recording
  • MCU / Flash / GPIO control via HID / Vender command interface (MCU read/write support 16 bytes data transfer bandwidth)
  • Supports up to 12 GPIO pins
  • Single 5V power supply with embedded 5V-to-4.5V and 5V-to-3.3V regulators

Audio I/O

  • 2-channel DAC outputs with 16-ohms headphone amplifier (support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.)
  • 2-channel ADC inputs (support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.)
  • Supports stereo microphone inputs with independent voltage bias pins and analog mixer (monitoring) function
  • Supports ADC DC offset cancellation high-pass-filter
  • Supports optional digital S/PDIF output
  • Configurable USB audio topology to Headset/Speaker/Microphone modes by internal 8051 MCU

Control Interfaces

  • Featured with Microsoft® HID controls including Vol_Up / Vol_Dn / Playback_Mute / Record_Mute / Play_Pause / Stop / Previous / Next hot-key buttons (enabled by default)
  • Optional analog DC VR volume control pin with internal ADC potentiometer
  • I2C/SPI/UART master/slave mode control interface
  • Supports Tri-color PWM LED indicator control pins(GPIO4,GPIO5,GPIO6)

General

  • Industrial standard small footprint LQFP-48 green package

Driver

  • Dolby Headphone V2 Driver
  • Pro-Logic IIx
BLOCK DIAGRAM
USB Audio,PCIe audio,USB audio ic,USB sound chip
TOP